Main Page Sitemap

Oscillatory rheology frequency sweep

For more information on this source, please visit.
The length of the lver of the elastic modules (G can be used as a measurement of the stability of a sample's structure, since structural properties are best related to elasticity.
Non-associated particulate dispersion zenni promo code today with viscosity almost independent of frequency.
A paint or pigmented coating is basically a dispersion of pigment particles in a fluid matrix.The complex viscosity is also now dependent on the frequency.When the material is later released, this unused stored energy acts like a driving force for reforming the structure into its original shape.In contrast, the elastic portion of energy is stored in the deformed material;.e.Figure 2 shows a weakly- structured system.Under favourable terms for this kind of samples this method can give a conclusion about their shelf life (sedimentation stability If for low frequencies G' G the dispersed particles should due to their gel structure still float and not sediment).Sponsored by, malvern Panalytical, jun 6 2005, background.Some examples are considered in the following frequency sweep data sets.One of the best techniques for determination of sample microstructure is oscillation (dynamic) testing.

Will induce some sort of structure upon the bulk phase.Geometry : Cone and plate system 4/40 mm with a solvent trap.Similarly, the effectiveness of surfactants and other colloidal thickeners can be quantified in situ.However, the difference between these is less good gifts that start with j great than in the non-associated system.In this case particles are strongly associated, the storage modulus (G is greater than the loss modulus (G and both are almost independent of frequency.Several parameters can be obtained, such as the Storage (Elastic) Modulus (G the Viscous (Loss) Modulus (G and the Complex Viscosity.Paints, cosmetics, comestible) the frequency sweep is less informative.The measurement results can be superposed to significant master curves.This friction always goes along with the development of frictional heat in the sample, and consequently, with the transformation of deformation energy into heat energy.